五月婷婷一区二区,亚洲国产午夜成人福利AV,91av视频在线,日韩精品一区二区三区无码视频

Outer Diameter of Rubber Roller

Measure 3-5 positions by micrometer or tape in the direction of plane length.

The locations are determined according to the inspection category of specifications. The length of glue is measured at three locations below 500 mm, and the length of glue is measured at a point below 150 mm.

Less than 0-0.5mm

Rubber roll cylindricity

The difference between the maximum value and the minimum value of the measured outer diameter.

Less than 0.05mm (rubber length less than 3000mm)

Less than 0.07 mm (rubber length over 3000mm L/D25 below)

Rubber roller hardness

A hardness tester is used to measure the hardness.

+ 3 degrees

True Roundness of Rubber Roller

The measurement difference of outer diameter at 90 degrees of the same circumference.

Less than 0.03mm

Rubber roll runout

When grinding cots, the runout accuracy of metal part (A.B) is adjusted below 0.02mm to ensure the runout accuracy of cots surface.

Less than 0.05mm

Medium and high shape

[medium and high volume]

[Outer diameter]

The outer diameter difference between the central part and the two ends is moderate to high.

The central part was measured and the number of times was taken as the outer diameter size.

+0.05 mm (below 0.5 for medium and high volume)

+0.1mm (above 0.5 for medium and high volume)

0-0.5mm

Rubber Roller Surface (Rubber) Length

Measure the length of rubber and the lowest reading value by touching the surface of rubber roll parallel to the measuring ruler or tape.

1 mm (face length less than 2000 mm)

2 mm (surface length over 2000 mm)